Concrete Remedy TS is effective as a sealer on surfaces which will be above or below grade.

Top Seal can be used alone, as a single product or it can be used in conjunction with
Concrete Remedy DS -- an internal densifier and hardener that also waterproofs
and reduces vapor transmission.

Top Seal penetrates approximately 1/16th inch into concrete. Penetration
rates vary according to the substrate. Concrete Remedy DS works only
internally, and leaves the top 1/16th inch clean so that other coatings or
adhesives or penetrating sealers will work well.

ADVANTAGES

Very Easy One coat application
Never any "peeling" or chipping -- maintains a good, natural appearance
Leaves clear, non-glossy finish
Does not produce the extreme slipperiness that surface build, shiny materials will.
Top Seal is safer in business and commercial settings.
Will not alter color or texture
Impervious to penetration of grease, oils, acids and salts
Stops pitting, rutting, dusting and molding
Enables easier ice and snow removal
Enables easy clean up of spills with mild soap and water

COVERAGE RATES
Coverage rates with Concrete Remedy TS depend on the porosity of the
surface being treated. I.e. concrete floors finished with a power trowel
then treated with Concrete Remedy DS will use much less Concrete Remedy TS
than paving stones which have never been treated with anything and have visible pores.
Coverage can range from 100 to 300 square feet per U.S. gallon.

CAUTION - PLEASE NOTE
Top Seal should not be used if the surface is going to later be painted
or coated over. Coatings will not stick to Top Seal without specific surface preparation.
Do not apply Concrete Remedy TS to glass, glazed surfaces, or aluminum, as etching
will occur. In case of accidental contact, rinse thoroughly and immediately with water.
Concrete Remedy TS is not meant to fill or seal visible cracks.
For surfaces not specified in our literature or if you are uncertain as to previous
chemical treatments, (on the surface to which you are considering applying
Concrete Remedy TS), we recommend that Concrete Remedy TS be applied
to a small test area first.

DO NOT ATTEMPT A SECOND COATING OF Concrete Remedy TS!
If Concrete Remedy TS becomes frozen, thaw out completely and shake well
to fully remix the material prior to using. Freezing will not harm the product.
Disclaimer

Since no control is exercised over product use, no warranty, expressed or
implied, is made as to the suitability of products for a particular use or as
to the suitability of products for a particular use or as to the effect of such
use, and no liability is assumed, directly or indirectly.